loading
reading
writing
saving
searching
CHEVY POWERGLIDE POWER GLIDE TRANS foot brake or transbrake - $750 (Douglassville, PA)
QR Code Link to This Post
can be used as it is with c02 brake or install 1/8" npt pipe plug into the side of the case where the reverse port case side port from the factory and convert it to a manually shifter powerglide (forward pattern)
CHEVY POWERGLIDE POWER GLIDE 1.82 RACE TRANSMISSION SETUP WITH C02 TRANS SPECIALTIES BRAKE
trans specialties 1.82 power glide / powerglide race trans setup (also have a near mint vintage hurts shifter assembly with hardware and cable for $200 addt'l)
trans has the manual valve body , converter is 9" diameter if i had to guess 4500 stall based on the cars et and 60' with a sbc 355 engine
as pictured
it works like this :
attach the fitting to the side of case near reverse piston , plumb 1/4" plastic hose to the solenoid switch , wire solenoid switch to the trans brake button . attach 1/4" plastic hose to the regulator ? co2 bottle. place trans in low gear .....push accelerator pedal down , push the trans brake button the trans will now be ready for release , you will need to manually shift the trans (its std pattern) alos to back up you will need to put shifter in reverse then push the trans brake button to back up.
included are : transmission specialties trans w/ 9" converter , co2 bottle w/ regulator . fittings , 12 volt solenoid , (NO AIR BOTTLE LINES)
was behind a 355 cid engine rand high 10's in the quarter.
keywords: drag car drag race racecar 55 57 chevy malibu ss wagon el camino camaro nova street race hotrod hot rat rod budget racer racing not th turbo 350 400 transmission tranny 2004r 700r4 muncie borg warner t10 3 4 speed overdrive od